home *** CD-ROM | disk | FTP | other *** search
/ Freaks Macintosh Archive / Freaks Macintosh Archive.bin / Freaks Macintosh Archives / Textfiles / zines / Midnight-Raid / midnight raid 8_app_640x480.sit / tmr 8 small.rsrc / TEXT_2300_13 Electric Explosions.txt < prev    next >
Text File  |  2000-01-09  |  3KB  |  56 lines

  1. onethree               @         13        @                     tr33n
  2.                        @Electric Explosions@ 
  3. 3teen                  @     Astrosmurf    @                     tHIRTEEN
  4.  
  5.  
  6.  
  7. 1 - explosions
  8.  
  9. There are a few electronic components that make nice explosions under certain
  10. conditions. The most common are:
  11.  
  12. Transistors
  13. These are quite easy to kill, especially the puny ones. Just wire a high voltage
  14. (30v or more) across any 2 legs and they pop quite nicely.
  15.  
  16. Diodes
  17. These explode about like transistors, and are usually cheaper.
  18.  
  19. Resistors
  20. If you double the voltage across a resistor the current will double, so the power
  21. dissapated will increase fourfold. It works especially well with small resistors
  22. which will give a higher current. They generally tend to heat up a lot and start
  23. to smoke a lot, but sometimes they fizzle and even make popping noises.
  24.  
  25. 741s
  26. A 741 is a basic operational amplifier - quite common and cheap. They can handle
  27. 30v(+15v to pin 8 and -15v to pin 4), but if you wire these up the wrong way round
  28. the poor little things can't cope. you'll either get some nice smoking and a cracked
  29. chips, or they will go bang and fly off in a few hot shards.
  30.  
  31. 555s
  32. A 555 is a timer chip that can be used to make oscillators and other useful things.
  33. They also make quite loud bangs. They run with up to an 8v power supply, but if you
  34. increase this they pop. It's best if you reverse the polarity, giving louder bangs
  35. than a 741.
  36.  
  37. Capacitors
  38. By far the best for exploding. The type you need to use are electrolytic capacitors,
  39. which are polarised. Obviously you have to wire them in the wrong way round, and
  40. about 30v should do (this depends on the specs of the capacitor...some are built
  41. to withstand a lot of damage) for a small capacitor. A few ¬µFs is the kind of size
  42. you're looking for. The capacitor has some wierd chemicals inside to help it work,
  43. but when it's wired in the wrong way with too much voltage the capacitor heats up
  44. very fast. So fast that the chemicals vaporise almost instantly and rip the whole
  45. thing apart with the insides flying everywhere, leaving nasty (and probably toxic)
  46. fumes in the air. Bigger capacitors give bigger explosions (just like more dynamite
  47. gives bigger explosions) but are harder to kill. If it's a bit hard going, just wire
  48. it across the mains and it'll make a nice loud bang, and probably trip some circuit
  49. breakers somewhere.
  50.  
  51. note: if you plan on doing any of this, stand well back (this can be done easily
  52. by leaving a gap in the circuit and 2 long wires running to where you are, so you
  53. can touch them together and you'll be safely round a corner or in the toilet or
  54. whatever). Another thing to watch out for is that some of these things take time,
  55. especially capacitors. I've known them to look harmless for half a minute before
  56. exploding in your face when you look to see what's wrong.